Search results for: 'inside sx small chlorinators'

As an all-in-one spa and hot tub treatment kit, the SpaBoss Hot Tub Chemical Starter Kit has everything you need to get your spa or hot tub up and running — and ensure it is always safe and ready to use. As a six-piece hot tub treatment kit, it’s quite an economical option, too!

The Hot Tub Chemical Starter Kit (SKU: X777700) includes:

• Granular pH Plus (1.5 lbs)
• Granular pH Minus (2 lbs)
• Granular Non-Chlorine Shock (2 lbs)
• Granular Chlor-Aid (2 lbs)
• Liquid Prevent II (16 oz)
• AquaChek Test Strips (50 Strips)

Measure the chemical balance of your hot tub water with AquaChek Silver 7-Way Test Strips in just 15 seconds.

• Count: 100 test strips
• Tests for: Total Hardness, Total Chlorine, Total Bromine, Free Chlorine, pH, Total Alkalinity, Stabilizer (Cyanuric Acid).

Replacing fuses in your spa’s PC board is often a simple, straightforward solution to various problems that might arise with your spa or its features. The 20 Amp Power Input Fuse is a small piece in your spa’s PC board that allows your spa’s pumps to operate. Replacing this fuse allows you to continue to enjoy your spa and its features.

The heater gasket o-ring is a replacement part for the o-rings that come with your spa and support the heater gasket so that there is a tight fit. If you don’t see your model listed, it may still work – so please give our customer service a call!

The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.

Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).

The 20 Amp, ABC20 Glass Fuse for H2X by Master Spas is a replacement fuse designed to go in your home spa’s PC board. It is important to keep the fuses in your spa’s PC board in good shape because they provide power to your spa and all of its features.

6' Resistance Cord

4.5' Resistance Cord

If replacing one suction cover, it is highly recommended that you replace all of them to be compliant. These suction covers are available for replacement of your older suction covers (spa models pre-2009). There is however no guarantee that these suction covers will fit your pre-2009 spa.

Activate and enhance the performance of your Spa Ease Bromine Tablets with the use of the Spa Ease Bromine Bank

Visionlift Pads provide a place for your Visionlift Boomerang cover lifter to rest – that’s not on the ground! They keep your cover lifter from getting scratched or torn up on the ground/deck.

SpaBoss Descummer boosts the effectiveness of the filtration system in your spa or hot tub, helping to keep the water clean and free of left-over contaminants.