Search results for: 'flo through heater foam st'
- Did you mean
- flo through heater forc st
- Related search terms
- Heater Gasket O-Ring for Master Spas X801765
- Flo master 1.5 hp single speed spa pump 120 volts
- FLOATING SPA COVER - 8 FT X 8 FT
- Foam divider between hot tub and swim spa
- heater for 2015 Master Spas Twilight series Hotub
The 7x7 Master Spas® hot tub replacement cover (84” x 84”) is a Master Spa Factory OEM replacment (SKU: X454777).
This cover fits other makes of Master Spa, and is the standard at 84" x 84" with a 6" radius.
This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.
-
The 78" x 66" Hot Tub Cover (Long-edge Fold) is an exact Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated.
Note: This particular cover folds along the longer 78" edge. If you need a cover with these same dimensions (66" x 78") but that folds along the short edge, try our 66 × 78 Inch Hot Tub Cover (Short-edge fold).
-
This product is a pressure switch assembly specifically designed to go with select Down East and Legend Series Master Spas. If you don’t see your model listed, it may still work – so please give our customer service a call!
-
Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.
This mount should fit with most sensors.
-
The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.
-
The sensor assembly is specifically designed to go with Down East Spas and Legend Series Master Spas (select 1996-1999 models). It is a replacement for Balboa Dual Sensor Assembly with Temperature and Hi-Limit Sensor. Compatible with all Balboa systems that use this type of sensor.
-
Designed specifically for 2015 Michael Phelps Swim Spas this sensor is a replacement for the sensor in your spa’s heating system allowing you to control the heat of your spa from the external control panel. If you don’t see your model listed, it may still work – so please give our customer service a call!
-
1 inch, Clear Rubber Grommet for Weir Waterfall
