Search results for: 'item pure spa h10 parts'

The 5 Amp Slow Blow (FST) by Master Spas is a replacement fuse made to go in your home spa. The fuse allows a greater level of power to flow without disrupting the circuit or blowing the fuse itself. The piece is affordable, easy to install and can be a simple fix for a problem with your spa

Replacement support arm for the CoverMate I Eco B and the inner support arm for the CoverMate Freestyle.

Did you know that the amount of microbes on filtration surfaces can double every 20 minutes? The warm water and organic materials are the perfect breeding grounds for germs. But, with the Pleatco H2X® Trainer & Michael Phelps filter PMA-R4, germs and microbes don’t even have a chance. Pick up your Swim Spa ECO PUR CHARGE System Filter from the Master Spa Parts online store, today!

Spa Touch for Swim Spas (S/N 50601)

General use number 8 stainless steel screws to fix and fasten surfaces securely are available to you from Master Spa Parts.

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

Once you have the SmartBar hot tub bar installed it’s impossible to go back to the old ways. Just picture always having your favorite drink, smartphone, or e-reader just a reach away. This spa-side bar installs easily and comes with everything you need to set up your soon-to-be favorite hot tub accessory.

39" L X 14" W

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

12V Power Supply for amplifiers. This 12V High Power DC Power Supply from Mean Well Electronics is an excellent source for your amplifiers allowing you to continue to enjoy sounds as you lounge in your spa/hot tub.

Free shipping for items over $99 for customers in the contiguous 48 states !

The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

The Master Spa Parts 8' x 18' cover (94" x 215") Master Spas® swim spa replacement cover is a Master Spa Factory OEM replacement part. All swim spa covers are made specifically to fit your Master Spas swim spa and come 6" thick in the middle and taper off to 4".  This cover includes an energy efficient 1.5 lb foam density and a 24 R-value, with a full length heat seal and upgraded rubber grip handles (included!). They are also available in 18 different colors to match the aesthetic of your hot tub area.

This heater is a replacement part for the original heater in your Legend Series Master Spas models 1996 through 2001.Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.