Search results for: 'ultra upper sts lifter frame mounted bracket'

Over time, your spa or hot tub’s air controls may wear out, leaving you with less jetting action and much less enjoyment and relaxation. With the 1 Inch Molded Air Control (Grey), Master Spa Parts customers can affordably replace their air controls. This part is compatible with many models of Down East Spas, Freedom Spas, and the Master Spas® Legend Series.

Plastic Stop for CoverMate III

The CoverCatch helps keep your spa cover close by and off the ground! It is ideal for smaller sizes spas and covers.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

Enjoying remote access to your favorite television shows is easy with this simple plug and play remote eye for your flat screen TV is perfectly suited for TV systems mounted with the Master Spa Hot Tub Series.

Visionlift Pads provide a place for your Visionlift Boomerang cover lifter to rest – that’s not on the ground! They keep your cover lifter from getting scratched or torn up on the ground/deck.

This is the Right Support Arm for the CoverMate III Eco B cover lifter.

*To determine if this is the correct replacement support arm need, look at your cover in the open position. While facing the spa and open cover lifter, the right support arm is on the right side.*

Foam Kickboard

PR-Weir Anchor DSG

Replacement screw kit for CoverMate Easy cover lifter. This kit includes all of the replacement screws for your cover lifter.

12 Amp, 1 Speed, 230 Volt, 56 Frame LX Pump

PREMIUM UNDERMOUNT HOT TUB COVER LIFTER
-Works with all cover shapes
-Undermount design- no screwing into spa
-Gas spring assisted

**Swim spa kit available for units up to 54" tall