Search results for: 'undermount sp2 lifter replacement arm'

Visionlift Pads provide a place for your Visionlift Boomerang cover lifter to rest – that’s not on the ground! They keep your cover lifter from getting scratched or torn up on the ground/deck.

The right cover piece snaps into the fitted location on the right side and covers all the pieces on that side.

*To determine if this is the correct replacement cover piece you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the right cover piece is on the right side.*

Replacement screw kit for CoverMate III DeckMount brackets

This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.

This replacement plastic screw kit is the main screw kit you need for your CoverMate 1 by Leisure Concepts.

This is the OEM factory replacement screw kit for your CoverMate CoverShelf.

This ball stud for the CoverMate III SKU 100244 are the direct replacement parts for the original ball studs on your hot tub cover lift.
**These are sold individually**

Plastic Bracket for CoverMate I and II

Boomerang brackets (1 pair) are specifically designed for use with the Visionlift Boomerang Cover Lifter by Ultralift. These brackets attach to your existing Ultralift sliding bracket, allowing your hot tub cover to fully open to the ground without the need for additional drilling. 

As the "command center" of your spa, the circuit board is tasked with making sure your blowers, lights, air filtration system, and high-limit sensors work correctly. Whether you're looking to replace your Down East Spas MS510/1500/1600 Ext. PCB (V/N 53681) or another unit, Master Spa Parts offers a vast selection of replacement circuit boards. These are all competitively priced and ready to ship.

The Circuit board replacement for Twilight Series™ Spas always ships typically within 24 hours to customers ordering this and other spa circuit boards through the Master Spa Parts online store.

The CoverMate II Understyle Cover Lifter is there for you when you need it and tucked away in the background while your hot tub is in use! It has two plates that slide easily underneath your hot tub. The cover lifter only requires 18 inches of clearance behind your spa.

This kit is a factory direct, replacement screw kit that contains a bag of screws used for installation with the CoverMate III Eco B.