Search results for: 'spa parts lock veri'

General use number 8 stainless steel screws to fix and fasten surfaces securely are available to you from Master Spa Parts.

The Upper Bracket Assembly attaches to the pivot arm, which allows a smooth opening and closing of your CoverMate Freestyle.

This Master Spa Factory OEM 78” x 78” hot tub cover replacement (SKU: X120240)  is specifically designed to fit your Master Spas® hot tub. This cover is energy efficient as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full length heat seal to help prevent heat loss. It is also made of a high end marine-grade vinyl covering that is mildrew treated, and consists of upgraded rubber grip handles.

Built specifically for Master Spas Legend Series models, the MS8000 System Pack (V/N 53231) is the perfect replacement for your spa’s original control pack.  Install this genuine, OEM control pack to keep your spa running smoothly!

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

The right cover piece snaps into the fitted location on the right side and covers all the pieces on that side.

*To determine if this is the correct replacement cover piece you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the right cover piece is on the right side.*

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

This left cover piece for the CoverMate III cover lifter snaps into the fitted location on the left side and covers all the pieces found there.

*To determine if this is the correct replacement cover pieceyou need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left cover piece is on the left side.*

The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

This heater is a replacement part for the original heater in your Legend Series Master Spas models 1996 through 2001.Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The replacement Lower Bracket Assembly attaches to the pivot arm, which allows a smooth opening and closing of your CoverMate Freestyle.

Swim Spa Grate