Search results for: 'swirl st lifter kit'

The right cover piece snaps into the fitted location on the right side and covers all the pieces on that side.

*To determine if this is the correct replacement cover piece you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the right cover piece is on the right side.*

This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.

Measure the chemical balance of chlorine based water with AquaChek Chlorine 4-in-1 Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Free Chlorine, pH, Total Alkalinity, Stabilizer (Cyanuric Acid)

The Down East Spas-manufactured six-button topside pump control decal is carried by Master Spa Parts at a tremendous value. This decal features the same graphics, tactical feel, and precision cuts as your original Cape Cod 3, Exeter 3, Portsmouth 3, Windsor 3, or Windsor 3 STS spa.

Order the Down East 2-Pump, 6-Button Overlay 2010 from the Master Spa Parts online store, today!

Measure the chemical balance of bromine based water with AquaChek Red 4-in-1 Bromine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity and Total Hardness

The 2 Inch Diverter Valve in Grey by Master Spas is a replacement for your home spa’s original diverter valve, the part of your spa that allows you to control jet water flow. This assembly kit comes with all of the pieces you need to install a new diverter valve in your spa.

This support arm lower for CoverMate Easy by Leisure Concepts is a direct OEM replacement for your original hot tub cover support arm.

Have your original Down East Spas single or dual-pump topside control decal seen better days? Master Spa Parts offers the high-quality, OEM Overlay for Down East 1 & 2 Pump for MP30. This waterproof laminate will restore the function and appearance of your Down East Spa model’s topside controller.

This ball stud for the CoverMate III SKU 100244 are the direct replacement parts for the original ball studs on your hot tub cover lift.
**These are sold individually**

This is the Plastic Bracket Right for CoverMate III and it is a replacement part for your CoverMate III Cover Lift. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate III Cover Lift. This part retails for $47.20 here at Master Spa Parts.

**To determine if this is the correct replacement bracket you need, look at your cover in the open position. While facing the spa and open cover lifter, the right bracket is on the right side.**

The Extended Pivot Arm for CoverMate I is one of the parts that makes up this model of a hydraulic cover lifter. This Extended Pivot Arm has SKU# 100591 and is a replacement part for the CoverMate I, which is sold here by Master Spa Parts. It is recommended that you do not use the CoverMate I during high winds as to protect the cover and the hydraulic cover lifter from possible damage.

The support arm lower for the CoverMate II is the direct replacement of the lower support arm in the bar that rest on the base of the hot tub.