Search results for: 'Waterway Pump Union 2” Slip With Tailpiece O-Ring White 2"'
- Related search terms
- Waterway Cartridge Filter, Top Load, 25 sqft, 1-1/2" s #500-2510
- slip pads for bottom swim spa
- 2” spa hose coupler
- white spa cover 15 x 8
- 2” jet body for 2005 spa
The 2 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.
Get all the parts you need to fully assembly your replacement spa pump.
-
O-Ring for WaterWay Executive 48/56 Wet End
-
2 x 2 inches Heater Tailpiece with Gasket
-
The 2 inch Standard Pump Union is a standard pump union used for complete assembly of your replacement pump. Should fit any 2 inch end on most pumps.
-
The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.
Make sure to buy all the parts you need for complete assembly of your replacement pump.
-
The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.
Get all the parts you need to fully assembly your replacement spa pump.
-
The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.
