Search results for: 'amplifier spx 360 part live 938ld.pcb'

This is the Locking Shock for the Cover Valet.

This locking shocks for your Cover Valet are the OEM, replacement part for the original shocks on the cover valet equipment.

The Coupler insert (2 per unit) is a long part used to lengthen your raise and lower bar for your hot tub cover.

The Shock Locking for CoverMate III Eco B is one of the parts that make up this economically efficient choice for a hydraulic cover lifter. The Shock Locking connects to the shock itself and is sold for $34.50 by Master Spa Parts. It is recommended that you do not use the CoverMate III Eco B during high winds as to protect the cover and the hydraulic cover lifter from possible damage.

The Windsor STS TV Lift Stand is a replacement TV Lift for your Windsor Spa Model STS (standard television set). Enjoy your favorite TV programming in your tub from any angle.

The Grey Terminal Block for H2X is designed specifically to work with your H2X Swim Spa. Feed through up to 750V through this Terminal Block.

Complete 3 inch Light Assembly

Measure the clear out side ring if it has a 5" diameter this is the wrong part. Take a look at part number X259255 this maybe the part you are looking for.

The Left Support Arm for CoverMate III Eco B is one of the parts that makes up this economically efficient choice for a hydraulic cover lifter. The Left Support Arm connects to the support arm and is sold here by Master Spa Parts. Prevent possible damage to the lift by remembering to unlock the shock before pulling the CoverMate Cover down.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left support arm is on left side.*

The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.

The O-Ring for Power WOW Drain Plug is the O-ring that goes with the drain plug for the Pentair Power WOW pump (SKU : X275230).This creates a tight seal for wet end drain.

The heater gasket o-ring is a replacement part for the o-rings that come with your spa and support the heater gasket so that there is a tight fit. If you don’t see your model listed, it may still work – so please give our customer service a call!

The 20 Amp Fuse by Master Spas is an exact replacement part for your original fuse. It is made to go in your spa’s PC board and supply power to the rest of your spa and its features. The piece is durable, affordable and will provide prolonged enjoyment of your spa.

This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.