Search results for: 'total fit swim spa rubber replacement frame rios bar'

The right cover piece snaps into the fitted location on the right side and covers all the pieces on that side.

*To determine if this is the correct replacement cover piece you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the right cover piece is on the right side.*

The pivot arm is a direct replacement for the original bar on the CoverMate I and CoverMate I Eco B.

This left cover piece for the CoverMate III cover lifter snaps into the fitted location on the left side and covers all the pieces found there.

*To determine if this is the correct replacement cover pieceyou need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left cover piece is on the left side.*

Overlay, MP Domestic Swim Side

The coupler is used to connect the lower and side portions of your CoverMate Easy product.

Our Master Spas® 83" x 70" hot tub cover (SKU: 458771) is a factory direct OEM replacement cover specifically designed to fit your Master Spas® hot tub. Consisting of 1.5lb foam density, long steam stopper cushions, six-inch foam insulation, four inch tapered sides, upgraded rubber grip handles and a 24-R value (the greater the R-value, the better the heat storage and heat retention), this cover prevents heat loss and is extremely energy efficient.

Note: This hot tub cover folds along the long edge.

This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.

Swim Turbo Power Stainless Steel Insert

The Neck Jet Pillow from Master Spa fits in place of the hot tub pillow that came with your hot tub.

The support arm lower for the CoverMate II is the direct replacement of the lower support arm in the bar that rest on the base of the hot tub.

The 84" x 94" Hot Tub Cover is a Master Spa Factory OEM replacement (SKU: x458494). It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.

Note: This particular hot tub cover folds along its shortest dimension (the 84" side).

Measure the chemical balance of bromine based water with AquaChek Red 4-in-1 Bromine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity and Total Hardness