Search results for: 'assist cover17 lift gas pismo non locking part'

This heater is a replacement part for the original heater in your Legend Series Master Spas models 1996 through 2001.Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The 4.0kW Heater (V/N 55950) is a replacement part for selected models of the H2X Swim Spas (Momentum 80, H2X Momentum) and Michael Phelps Swim Spas (Momentum 80)

Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The 1.5 inch Pump Split Nut is a replacement part for your pump union that needs to be re-plumbed.

Need to replacement your entire pump unit ? Don’t forget to buy all the parts you need to fully assemble the pump.

The pressure switch - MAS400 - is specifically designed to replace the original pressure switches in the Legend Series Master Spas 2000 CS models. Control the water pressure in your spa with the right part.

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

Designed specifically for the Legend Series Master Spas and the Michael Phelps Swim Spas starting with the 2014 model, the Temperature Sensor Mount is a replacement part that will fit the temperature sensor (SKU : 801821). If you don’t see your model listed, it may still work – so please give our customer service a call!

Protect your speaker from excessive vibrations using the 80W Speaker Spider. The 100W Speaker Spider centers moving parts of the speaker allowing vibrations in an in and out motion instead of moving from side to side which can destroy your speakers.

The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.

Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).

The CoverCatch helps keep your spa cover close by and off the ground! It is ideal for smaller sizes spas and covers.

The 8.8 Amp 2 speed 56 Frame Pump from Master Spa Parts is designed for flexibility and performance.

The CoverMate I with Master Bracket is designed for 2014 and older Master Spas swim spas. The “Master Bracket” is designed to screw into the wood frame of the swim spa behind the corner. This gives your cover lifter a way more secure attachment to your swim spa!

The 108" x 94" Master Spas® replacement hot tub cover (SKU: X454994) is designed to fit your Master Spas® hot tub. This OEM factory hot tub cover comes with a 1. lb foam density, upgraded rubber grip handles and long steam stopper cushions to help prevent heat loss and make it extremely energy efficient!

Note: This cover folds along its longest dimension.