Search results for: 'power master 35 covers pm 2'
- Did you mean
- power master 35 cover17 pm 2
- power master 35 cover13 pm 2
- Related search terms
- Master Spa - CLSEPRSET3 - Clarity & Healthy Living EPR Filter Set - (2) X268548 - PMA-R3 and PMA-EPR - (1) X268532
- Master Spas - X268532 - PMA-EPR, Eco Pur Charge Master Core Technology Mineral Filter - X268532
- master spa down east legend 2007 drain plug
- Master Spas - Х310223 Topside Control, MP2 ST1 Custom SFTW, H2X Swim Spa, MP2 X310223 (New Part Number X310334)
- Master spa - X277700 2 inch heater tailpiece
Controlling your spa experience starts with keeping up with your spa's maintenance. The Grey, 2 Inch Diverter Handle by Master Spas is a replacement piece for your spa’s original diverter valve handle. This piece allows you to switch your diverter valve off and on, thus controlling the flow of water in your spa.
-
This is the replacement right aluminum bracket or your CoverMate Cover Lifter by Leisure Concepts.
*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the right bracket is on the right side.*
-
The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.
Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).
-
This 67" x 78" Hot Tub Cover (Short-edge Fold) hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures you energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation that tapers to 4-inches along the sides, and a full-length heat seal to prevent heat loss. Additionally, it is made of a high-quality marine-grade vinyl covering that is mildew treated and protects against UV rays. Additionally, it boasts upgraded rubber grip handles.
Note: This particular hot tub cover folds along the shorter 67" edge.
.
-
The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.
-
The 66" x 78" Master Spas® factory direct OEM replacement hot tub cover (SKU: 66x78) is designed to fit your Master Spas hot tub. It comes standard with a 1.5lb foam density, long steam stopper cushions to help prevent any sort of heat loss. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.
Note: This particular cover folds along the short edge. If you need a cover with these same dimensions (66" x 78") but that folds along the long edge, try our 66 × 78 Inch Hot Tub Cover (Long-edge fold).
