Search results for: 'SUCTION COVER FOR XP2 SPA PUMP'

Auxiliary pump button overlay.

Auxiliary Pump 4 Panel (V/N 52806)

3-Way Jumper for MS5000. Wire jumper for components to plug into one spot on the pc board. Usually used with the circulation pump and ozone.

12 Amp, 1 Speed, 230 Volt, 56 Frame LX Pump

16.4 Amp, 2 Speed with 9 O'Clock position Wet end 

This right support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the right arm is on the right side.*

The Master Spas Freeze Plug Kit contains a plug set that works on most spa pumps. This can be loosened to drain any trapped fluid within your pump. Replacing a broken pump ? Make sure to get new freeze plugs as well.

Support arm for CoverMate I and upper support arm for the CoverMate II and CoverMate Easy.

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*

The 7' x 6.5' (84" x 78") Master Spas® replacement hot tub cover (SKU: X454765) is a Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.

Twilight, 2 Pump, 6 Button Overlay

Twilight, 1 Pump, 5 Button Overlay