Search results for: 'modul pump frame master six ls750'
- Related search terms
- Master Spa - CLSEPRSET3 - Clarity & Healthy Living EPR Filter Set - (2) X268548 - PMA-R3 and PMA-EPR - (1) X268532
- Master Spa - X232607 - 1" Lighted Halo Air Control
- Master Spas - Topside Panel, MP900, No Overlay, For MS40 - X310203, 50305
- Master Spa - X245375 - 2 inch DSG 6-Spoke Diverter
- Master Spas, Down East, Emerald Spas Suction Drain Cover, 4-7/8 inch 0.D. VGB Law Compliant Replaced 0bsolete Original
This is the replacement right aluminum bracket or your CoverMate Cover Lifter by Leisure Concepts.
*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the right bracket is on the right side.*
-
This is the replacement Bracket Kit for CoverMate II and it can be screw-mounted low on the spa. The Bracket Kit for the CoverMate II is for a model that needs only 18 inches of clearance behind the spa in order to operate. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate II Cover Lift. This part is sold for $73.45 here at Master Spa Parts.
-
The Extended Pivot Arm for CoverMate I is one of the parts that makes up this model of a hydraulic cover lifter. This Extended Pivot Arm has SKU# 100591 and is a replacement part for the CoverMate I, which is sold here by Master Spa Parts. It is recommended that you do not use the CoverMate I during high winds as to protect the cover and the hydraulic cover lifter from possible damage.
-
The 7' x 6.5' (84" x 78") Master Spas® replacement hot tub cover (SKU: X454765) is a Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.
Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.
-
The heater gasket o-ring is a replacement part for the o-rings that come with your spa and support the heater gasket so that there is a tight fit. If you don’t see your model listed, it may still work – so please give our customer service a call!
-
This Master Spa Factory OEM 79" x 69" hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures energy efficiency as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.
Note: This 79" x 69" hot tub cover folds along the long edge.
-
Mini-Storm Multi-Massage with M.S. Logo
-
Poly-Storm Multi-Massage with M.S. Logo
-
3-Way Jumper for MS5000. Wire jumper for components to plug into one spot on the pc board. Usually used with the circulation pump and ozone.
