Search results for: '10 round sp1 cover17 4 turbo custom custom'

Cooper Heater Strap. This is the shorter style of the 3 we have in stock (SKU #: 300016, SKU #: 300390). Copper construction provides easily installation for connecting your spa heater to the PC Board.

The support arm lower for the CoverMate II is the direct replacement of the lower support arm in the bar that rest on the base of the hot tub.

Choosing the right filter for your spa is one of the best ways to keep your spa water clean and clear. Pleatco® filter PMA40L-F2M also help your hot tub's pumps and other mechanical functions work efficiently. With this skimming filter, Master Spa Parts is helping customers extend the lifetime of their spas and get a great deal. Pick up your replacement filter, today!

Designed for outdoor projects that involve a wood-to-wood connection. Keep the parts of your spa well-fastened and ensure safe use.

The right outer handle is a powder-coated aluminum part that is used to easily open and close your CoverMate Freestyle.

*To determine if this is the correct replacement handle you need, look at your cover in the open position. While facing the open cover, the right handle is on right side.*

The 11 amp, 2 speed 120 volt Pump is an insulated wet end pump designed as a replacement pump.

This is an OEM factory direct replacement drain valve for your Master Spa with an on/off and hose connection.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.

Keep your entertainment system protected from the elements and theft with this universal lock and key set. Can work as a replacement for your original lock on your spa’s entertainment system.

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

The Master Spa® Factory OEM 82" x 60" replacement hot tub cover (SKU: x458260) is specifically designed to fit your Master Spas® hot tub. This replacement custom hot tub cover ensures energy efficiency as it consists of a 1.5lb foam density, 6-inch thick foam insulation that tapers to 4-inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

Note: This hot tub cover (82" x 60") folds along the long edge.