Search results for: 'monte out frame spa'

The Master Spas® hot tub replacement cover 70" x 84" is an exact Master Spa Factory OEM replacement (SKU: X457084). It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and protects against UV rays.

Note: This particular hot tub cover folds along the short edge. Find the corresponding long-edge fold cover here.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

A circuit board that's failed can put an end to your evenings of relaxation. We can help you bring back the good times with this Down East Spas and Master Spas® Circuit Board MAS425 PC Board (V/N 52364). Plus, you’ll spend much less than you would typically from your local repair shop! To make the offer even more attractive, our MAS425 replacement circuit board comes with free shipping to most United States locations (excluding Alaska and Hawaii).

Control your spa entertainment system using this waterproof unit. UV and Salt resistant Wired Stereo Remote is designed and built to withstand the harsh conditions that come with spa use.

Replacement Control Panel for Michael Phelps Swim Spas

MP8 Control Panel

This all-in-one Water Care Kit maintains clean, clear water for your spa daily, weekly and annually. Maximize your spa experience with these three SilkBalance products: SilkBalance (Water Conditioner, 38oz.), Shock Gems, and Clean Start. This kit includes 40 Gems (40oz.) per box.

General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.

Master Spa Parts makes it easy to replace your Legend® Series controller adhesive overlay for your 2014 or 2015 Michael Phelps hot tub. Not only are these attractive and created by the same manufacturer that crafted your original Michael Phelps Legend® Series Overlay, but they are offered at Master Spa Parts’ low, everyday prices. Plus, we ship out most orders within 24 hours!

Stainless steel 3/8" Hex Nut is designed to be used on the fastening components of your spa propulsion system. Stay safe and keep your spa components from coming apart.

The 11 amp, 2 speed 120 volt Pump is an insulated wet end pump designed as a replacement pump.

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

Your spa's circuit board carries your spa's blowers, lights, high-limit sensors, and other systems. If your original PCB, Lite Leader (V/N 54115) from Down East Spas has failed, Master Spa Parts can get you up-and-running in no time. When you buy your Lite Leader Board for Down East Spas from Master Spa Parts, you can expect it to ship out within 24 hours. Plus, shipping is free to all states (offer excludes Hawaii and Alaska).