Search results for: 'Spa cover parts'
- Did you mean
- sp1 cover17 parts
- sp1 cover13 parts
- Related search terms
- Spa pillow with sucktiin cups
- Spa pillow with sucktion cups
- spa model number kb340da2
- SPA FILTER Clarathon Antimicrobial PWW50L
- Spa accessories for Thera pool 13
Built specifically for Master Spas Legend Series models, the MS8000 System Pack (V/N 53231) is the perfect replacement for your spa’s original control pack. Install this genuine, OEM control pack to keep your spa running smoothly!
-
3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.
-
The Coupler insert (2 per unit) is a long part used to lengthen your raise and lower bar for your hot tub cover.
-
The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.
-
The CoverMate II Understyle Cover Lifter is there for you when you need it and tucked away in the background while your hot tub is in use! It has two plates that slide easily underneath your hot tub. The cover lifter only requires 18 inches of clearance behind your spa.
-
The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.
Get all the parts you need to fully assembly your replacement spa pump.
-
This heater is a replacement part for the original heater in your Legend Series Master Spas models 1996 through 2001.Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.
-
The hydraulic shock is used to support your CoverMate III cover shelf. Easily open and close the hot tub cover with the use of the hydraulic shock that will support the weight of the cover with ease.
-
This is the Right Support Arm for the CoverMate III Eco B cover lifter.
*To determine if this is the correct replacement support arm need, look at your cover in the open position. While facing the spa and open cover lifter, the right support arm is on the right side.*
-
Designed for adding a beautiful finish to your spa, the mahogany oversized snap cap goes over the screws that hold your spa side panels on. Color - mahogany.
-
The 4.0kW Heater (V/N 55950) is a replacement part for selected models of the H2X Swim Spas (Momentum 80, H2X Momentum) and Michael Phelps Swim Spas (Momentum 80)
Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.
