Search results for: 'swim4 6 6 6 6 sx side panel'

2 x 3/4 inch 2 Barb SxSp Manifold

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*

Designed specifically for 2015 Michael Phelps Swim Spas this sensor is a replacement for the sensor in your spa’s heating system allowing you to control the heat of your spa from the external control panel. If you don’t see your model listed, it may still work – so please give our customer service a call!

1 Pump overlay for Clarity spas with the TP 500S Control panel

SpaBoss pH Plus easily raises pH levels in spas and hot tubs that are too low below the recommended safe range of 7.2 to 7.6. If levels are too low, your hot tub water can become acidic and other nasty side effects can happen.

The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.

Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).

Wave Propulsion Control System

This Master Spa Factory OEM 79" x 69" hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures energy efficiency as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.

Note: This 79" x 69" hot tub cover folds along the long edge. 

This Master Spa Factory OEM 66" x 84" hot tub cover replacement (SKU: X456684) is specifically designed to fit your Master Spas® hot tub. This cover ensures energy efficiency as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.

Note: This particular hot tub cover folds along the short edge. Find the corresponding long-edge fold cover here.

This is the replacement right aluminum bracket or your CoverMate Cover Lifter by Leisure Concepts.

*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the right bracket is on the right side.*

H2x Mp30 Overlay

Complete 3 inch Light Assembly

Measure the clear out side ring if it has a 5" diameter this is the wrong part. Take a look at part number X259255 this maybe the part you are looking for.