Search results for: 'service foot my spa'

The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.

Make sure to buy all the parts you need for complete assembly of your replacement pump.

Copper Heater Straps. These are the longer style heater straps. These are the most common heater straps. These heater straps are used to connect power from the PC board and the heater.

The 1.5 inch standard pump union is a universal pump union used for complete assembly of your replacement pump. Should fit any 1.5 inch end on most pumps.

You need this to fully assemble your pump.

The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.

KEC Remote Eye. Control your spa’s theater system from the comfort of your hot tub. The KEC Remote Eye turns your clicks on your remote into executable commands that allow you to switch the channels on your television or radio.

3-Way Jumper for MS5000. Wire jumper for components to plug into one spot on the pc board. Usually used with the circulation pump and ozone.

Putting on and taking off spa and hot tub covers can be tiring for even physically fit individuals. If you’ve put off getting a cover lifter because you haven’t found a cover lift that fits behind your spa, you’re in luck; CoverMate III only requires 6” of clearance space and locks shock locks into place — and that’s just a few of the many benefits of this customer-favorite hydraulic spa cover lift from Leisure Concepts.

**Please note: ALL COVER LIFTER SALES ARE FINAL.** 

Enjoy crisp radio AM/FM, Sirius and CD selections with the Clarion AM/FM/CD radio from the comfort of your spa. Built-in amplifier.

The O-Ring for Power WOW Drain Plug is the O-ring that goes with the drain plug for the Pentair Power WOW pump (SKU : X275230).This creates a tight seal for wet end drain.

13.5 inch SST Grab Bar for RX Swim Spa

If replacing one suction cover, it is highly recommended that you replace all of them to be compliant. These suction covers are available for replacement of your older suction covers (spa models pre-2009). There is however no guarantee that these suction covers will fit your pre-2009 spa.

MS8000 Relay for FST. This unit reverses polarity of the power in your spa’s entertainment system to raise and lower the television.