Search results for: 'swim 6 6 6 6 sx 12 flat long'
- Related search terms
- swim spa 15D
- Swim spa deluxecover
- swim spa built 2012
- swim spa kit for Trainer 15D
- swim H2X spa cover 156"x90"
PREMIUM UNDERMOUNT HOT TUB COVER LIFTER
-Works with all cover shapes
-Undermount design- no screwing into spa
-Gas spring assisted
**Swim spa kit available for units up to 54" tall
-
Extend the life of your spa cover with Spa Ease Cover Conditioner!
-
The Coupler insert (2 per unit) is a long part used to lengthen your raise and lower bar for your hot tub cover.
-
Designed specifically for 2015 Michael Phelps Swim Spas this sensor is a replacement for the sensor in your spa’s heating system allowing you to control the heat of your spa from the external control panel. If you don’t see your model listed, it may still work – so please give our customer service a call!
-
This ball stud for the CoverMate III SKU 100244 are the direct replacement parts for the original ball studs on your hot tub cover lift.
**These are sold individually**
-
Topside control panel extension cord 25'
-
This Master Spa Factory OEM 66" x 84" hot tub cover replacement (SKU: X456684) is specifically designed to fit your Master Spas® hot tub. This cover ensures energy efficiency as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.
Note: This particular hot tub cover folds along the short edge. Find the corresponding long-edge fold cover here.
-
This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.
