Search results for: 'sx non seri 6 6 6 6 6 part'

This is a OEM factory direct replacement rubber stopper smash cap for the CoverMate I hot tub cover. Easily replace your old smash cap with this replacement!

Billed as the “best budget-friendly spa cover lift,” CoverMate I Eco is the perfect low-cost solution to constantly getting help from a “cover buddy” — or, putting on and taking off your spa or hot tub on your own. The CoverMate I Eco from Leisure Concepts makes it totally easy to uncover and re-cover your spa.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

Hot tub cover removal and storage can be difficult, so why not make it easier with a spa CoverShelf by Leisure Concepts. When removing your cover, simply fold it in half and slide it into the shelf, made of sturdy aluminum bars. There, it can rest securely off the ground and without obstructing your view!

Connect your audio system to the controller of your Master Spa hot tub using this stereo adapter. Order the stereo adapter you need for your Master Spa controller today. 

The Blue Water metal remover spa pre-filter is designed with a proprietary filtration medium that includes food-grade carbon. This spa pre-filter works to remove up to 98% of heavy metals, as well as VOCs, TOCs, and other contaminants, allowing you to fill your spa from a variety of sources, such as city water, well water, hard or soft water.

Save money on your spa start-up and get clear water ever fill-up — order the Pure Fill Spa Pre-Filter from Master Spa Parts, today!

Ozone Flash Reactor

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.

The Drain Plug for Power WOW is a wet end drain plug for the Pentair Power WOW. This part does not come with an O-ring. The part allows the pump to be drained of stagnant water so protect it from damage and to keep it running for as long as possible.

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*

General use number 8 stainless steel screws to fix and fasten surfaces securely are available to you from Master Spa Parts.