Search results for: 'Tidalfit spa parts'

Designed specifically for 2015 Michael Phelps Swim Spas this sensor is a replacement for the sensor in your spa’s heating system allowing you to control the heat of your spa from the external control panel. If you don’t see your model listed, it may still work – so please give our customer service a call!

SpaEase Classic Espresso SteP

The Pivot Arm for CoverMate III Eco B is one of the parts that makes up this economically efficient choice for a hydraulic cover lifter. The Pivot Arm connects to the mounting brackets and the support arms and is sold here by Master Spa Parts. It is recommended that you do not use the CoverMate III Eco B during high winds as to protect the cover and the hydraulic cover lifter from possible damage.

This is the Lock Clip replacement part for your Master Spas Hot Tub Cover. This replacement piece is made of sturdy plastic and helps to keep your hot tub secure. Furthermore, it aids in preventing wind damage to the cover. This replacement piece has a SKU number of X900103 and is sold through Master Spa Parts.

This is the Extended Pivot Arm for CoverMate III and it is a replacement part for your CoverMate III Cover Lift. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate III Cover Lift. This part is 43 inches long and is sold here at Master Spa Parts.

Single Filter Housing for Swim Spas

Water can be rough on speakers. The 6.5-inch 2-way marine speakers are ready to take on whatever your Master Spa Hot Tub Series will throw at it.

Customers will enjoy clarity of audio and can rest assured that these speakers will not be destroyed by sun or an the occasional accidental splash of water.

MP Swim Spa, Swim Side Control Panel MP9

Trim Kit for Wave TR19/MOM Swim Spa

Save money with this three-piece EcoPur® Charge filter set! This set includes x268532, x268543, x268546 from Master Spa Parts (and replaces SKU #268603). 

The 2 inch Standard Pump Union is a standard pump union used for complete assembly of your replacement pump. Should fit any 2 inch end on most pumps.

The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.