Search results for: 'how to cmeas staining on sp2 tub from metals'

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*

Has the ball in your air control become stuck, or has it started to “whistle?” It is most likely time to replace it. Master Spa Parts has the perfect replacement part for you. The 1-Inch, MG Air Control w/ Blower Assist Tee is compatible with spas and hot tubs that accept a one-inch air control.

The SmartRail is a hand rail for recessed spas. With the SmartRail, Leisure Concepts solved the top pain points of those with recessed spas: finding a hand rail that is not only compatible with their setup, but one that is also easy to install. This product comes with free shipping to the Continental USA, compliments of Master Spa Parts.

This heater is a replacement part for the original heater in your Legend Series Master Spas models 1996 through 2001.Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

Master Spa Parts offers the Legend Series 3 Pump Overlay Set for Master Spas® line of best-selling spas. This decal is manufactured by Master Spas® to ensure a perfect fit. And, since you’re buying from Master Spa Parts, rock-bottom prices and fast shipping are always assured! Order your jet control decal for Master Spas® Legend Series (2005-2012), today!

The 1/4-20 Threaded Insert for Wood from Master Spa Parts are threaded nuts that can be hammered or screwed into material. Used in a pre-drilled hole to provide an extra secure hold between your spa skirting parts.

The Master Spa Parts 8' x 18' cover (94" x 215") Master Spas® swim spa replacement cover is a Master Spa Factory OEM replacement part. All swim spa covers are made specifically to fit your Master Spas swim spa and come 6" thick in the middle and taper off to 4".  This cover includes an energy efficient 1.5 lb foam density and a 24 R-value, with a full length heat seal and upgraded rubber grip handles (included!). They are also available in 18 different colors to match the aesthetic of your hot tub area.

Copper Heater Straps. These are the longer style heater straps. These are the most common heater straps. These heater straps are used to connect power from the PC board and the heater.

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

Many repair shops will quote astronomical prices on replacement circuit boards. A PCB is essential to your spa's proper operation, but that doesn't mean replacing one has to break the bank. With this MS8500 PC Board (V/N 55849) Master Spa Parts aims to restore the essential functions of your hot tub or spa — and do so economically. This and many other Master Spas® parts are in stock and ready to ship.

Those ordering this Replace Master Spas® MS8500 spa circuit board in the United States (excluding Hawaii and Alaska) will receive fast, free shipping — order yours today!

The support arm lower for the CoverMate II is the direct replacement of the lower support arm in the bar that rest on the base of the hot tub.