Search results for: 'spa lift cover17 parts'

Get the sound system in your spa area ready for action with up to four speakers with this wiring harness (SKU# X551417). Get your new wiring harness from the trusted source for Master Spas replacement parts.

Designed specifically for 2015 Michael Phelps Swim Spas this sensor is a replacement for the sensor in your spa’s heating system allowing you to control the heat of your spa from the external control panel. If you don’t see your model listed, it may still work – so please give our customer service a call!

SpaEase Classic Espresso SteP

This is the Lock Clip replacement part for your Master Spas Hot Tub Cover. This replacement piece is made of sturdy plastic and helps to keep your hot tub secure. Furthermore, it aids in preventing wind damage to the cover. This replacement piece has a SKU number of X900103 and is sold through Master Spa Parts.

Single Filter Housing for Swim Spas

Water can be rough on speakers. The 6.5-inch 2-way marine speakers are ready to take on whatever your Master Spa Hot Tub Series will throw at it.

Customers will enjoy clarity of audio and can rest assured that these speakers will not be destroyed by sun or an the occasional accidental splash of water.

The Master Spa® Factory OEM 84" x 70" replacement hot tub cover is specifically designed to fit your Master Spas® hot tub. This replacement custom hot tub cover ensures energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.

MP Swim Spa, Swim Side Control Panel MP9

Trim Kit for Wave TR19/MOM Swim Spa

Save money with this three-piece EcoPur® Charge filter set! This set includes x268532, x268543, x268546 from Master Spa Parts (and replaces SKU #268603). 

The 2 inch Standard Pump Union is a standard pump union used for complete assembly of your replacement pump. Should fit any 2 inch end on most pumps.

The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.