Search results for: 'lifter handle parts for storm spa har coverm'

General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.

This 7.5' x 13' Swim Spa Cover for your H2X Therapool swim spa is a folding cover for your swim spa! This cover is extremely easy to operate and it makes taking on and off your swim spa cover easier than ever.

The 5 Amp Slow Blow (FST) by Master Spas is a replacement fuse made to go in your home spa. The fuse allows a greater level of power to flow without disrupting the circuit or blowing the fuse itself. The piece is affordable, easy to install and can be a simple fix for a problem with your spa

Boomerang brackets (1 pair) are specifically designed for use with the Visionlift Boomerang Cover Lifter by Ultralift. These brackets attach to your existing Ultralift sliding bracket, allowing your hot tub cover to fully open to the ground without the need for additional drilling. 

This Master Spa Factory OEM 78” x 78” hot tub cover replacement (SKU: X120240)  is specifically designed to fit your Master Spas® hot tub. This cover is energy efficient as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full length heat seal to help prevent heat loss. It is also made of a high end marine-grade vinyl covering that is mildrew treated, and consists of upgraded rubber grip handles.

Did you know that the amount of microbes on filtration surfaces can double every 20 minutes? The warm water and organic materials are the perfect breeding grounds for germs. But, with the Pleatco H2X® Trainer & Michael Phelps filter PMA-R4, germs and microbes don’t even have a chance. Pick up your Swim Spa ECO PUR CHARGE System Filter from the Master Spa Parts online store, today!

Spa Touch for Swim Spas (S/N 50601)

The Master Spas® hot tub replacement cover 70" x 84" is an exact Master Spa Factory OEM replacement (SKU: X457084). It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and protects against UV rays.

Note: This particular hot tub cover folds along the short edge. Find the corresponding long-edge fold cover here.

The 108" x 94" Master Spas® replacement hot tub cover (SKU: X454994) is designed to fit your Master Spas® hot tub. This OEM factory hot tub cover comes with a 1. lb foam density, upgraded rubber grip handles and long steam stopper cushions to help prevent heat loss and make it extremely energy efficient!

Note: This cover folds along its longest dimension. 

General use number 8 stainless steel screws to fix and fasten surfaces securely are available to you from Master Spa Parts.

Built specifically for Master Spas Legend Series models, the MS8000 System Pack (V/N 53231) is the perfect replacement for your spa’s original control pack.  Install this genuine, OEM control pack to keep your spa running smoothly!

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.