Search results for: 'topside control foam down east spa extern 2 2009'

This 67" x 78" Hot Tub Cover (Short-edge Fold) hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures you energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation that tapers to 4-inches along the sides, and a full-length heat seal to prevent heat loss. Additionally, it is made of a high-quality marine-grade vinyl covering that is mildew treated and protects against UV rays. Additionally, it boasts upgraded rubber grip handles.

Note: This particular hot tub cover folds along the shorter 67" edge. 

.

This Master Spa Factory OEM 79" x 69" hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures energy efficiency as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.

Note: This 79" x 69" hot tub cover folds along the long edge. 

The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.

Make sure to buy all the parts you need for complete assembly of your replacement pump.

VSP Drive for H2X Challenger Pump 2

2 3/16" Directional Stainless Steel Jet

1/2" Slip Check Valve with Cap

The Master Diverter Valve Handle is a genuine oem replacement part for your Master Spas hot tub. Diverter valves are made to redirect the water from your spa into different directions, as well as fully (or partially) shutting off your hot tub water flow. This specific diverter valve has a 2”inch handle and has an all over width of 4.5” inches.

1/2" Sx3/4" Barb Adapter

This Master Spa Factory OEM 66" x 84" hot tub cover replacement (SKU: X456684) is specifically designed to fit your Master Spas® hot tub. This cover ensures energy efficiency as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.

Note: This particular hot tub cover folds along the short edge. Find the corresponding long-edge fold cover here.

2 inch Spx 3/4 inch Barb Adapter

1/2 x 3/8 inch Barb Adapter

1/2 inch Hose Valve On / Off Assembly