Search results for: '15 inch spa suction fitting'

Replacement Propulsion Control Panel for MP Swim Spas

ST2C

The Master Spa® Factory OEM 84" x 66" replacement hot tub cover is designed to fit your Master Spas® hot tub. This replacement custom hot tub cover is extremely energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.

Available at our low, everyday price, Master Spa Parts offers an outer filter PMA-R1 for select H2X®, Twilight, and Legend Series™ spas and hot tubs. This Eco Pur Charge product features advanced filtration technologies.

Order this filter for Twilight and Legend Series™ spas from the Master Spa Parts online store, today!

**This part replaces: X268325

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.

Measure the chemical balance of bromine based water with AquaChek Red 4-in-1 Bromine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity and Total Hardness

Modbus AC Drive for xp swim spas

Wiring Harness for Combo Swim Spas Stereo

The right cover piece snaps into the fitted location on the right side and covers all the pieces on that side.

*To determine if this is the correct replacement cover piece you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the right cover piece is on the right side.*

These 52” pivot arms allow for your Ultralift Undermount to be used with a selection of swim spas. This accessory is a great option if you own a swim spa and want to use the Undermount as your cover lifter.

This left cover piece for the CoverMate III cover lifter snaps into the fitted location on the left side and covers all the pieces found there.

*To determine if this is the correct replacement cover pieceyou need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left cover piece is on the left side.*

The 7' x 6.5' (84" x 78") Master Spas® replacement hot tub cover (SKU: X454765) is a Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.