Search results for: 'master sp2 parts online'

This ball stud for the CoverMate III SKU 100244 are the direct replacement parts for the original ball studs on your hot tub cover lift.
**These are sold individually**

The bracket kit for the CoverMate III by Leisure Concepts includes all direct replacement parts for the brackets on your CoverMate III.

Designed for adding a beautiful finish to your spa, the expresso oversized snap cap goes over the screws that hold your spa side panels on. This unit is a dark espresso color.

Foam Grip for CoverMate I, CoverMate III, CoverMate Easy and CoverMate Freestyle. This is the upper Foam Grip for the CoverMate II.

The Upper Bracket Assembly attaches to the pivot arm, which allows a smooth opening and closing of your CoverMate Freestyle.

The 70" x 83" Hot Tub Cover (Short-edge Fold) (SKU: 457187) is designed to fit your Master Spas® hot tub. This cover ensures extreme energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.

Note: This particular cover folds along the shortest 70-inch edge. For a hot tub cover folding on the long edge, please see 83" x 70" Hot Tub Cover (Long-edge Fold).

Contractor Series Filter PWW35L 2012, except CS 415.

This kit includes left and right brackets and screws for your CoverMate I Eco B. They are all factory direct, OEM replacement parts.

The replacement Lower Bracket Assembly attaches to the pivot arm, which allows a smooth opening and closing of your CoverMate Freestyle.

Designed specifically for 2015 Michael Phelps Swim Spas this sensor is a replacement for the sensor in your spa’s heating system allowing you to control the heat of your spa from the external control panel. If you don’t see your model listed, it may still work – so please give our customer service a call!

The Coupler insert (2 per unit) is a long part used to lengthen your raise and lower bar for your hot tub cover.

The right cover piece snaps into the fitted location on the right side and covers all the pieces on that side.

*To determine if this is the correct replacement cover piece you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the right cover piece is on the right side.*