Search results for: 'bar hot tub 1000 1000 heater'

BWG Heater Plug N Click Adapter

This adapter eliminates the copper straps going from the heater to the circuit board. 

**This needs to be used on all heaters that come with the plug that is already attached. Removing the plug on the heater will void the warranty.**

The 78" x 66" Hot Tub Cover (Long-edge Fold) is an exact Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated.

Note: This particular cover folds along the longer 78" edge. If you need a cover with these same dimensions (66" x 78") but that folds along the short edge, try our 66 × 78 Inch Hot Tub Cover (Short-edge fold).

The 7' x 6.5' (84" x 78") Master Spas® replacement hot tub cover (SKU: X454765) is a Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.

The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.

Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).

Heater Split Nut

13.5 inch SST Grab Bar for RX Swim Spa

4.0 kW Replacement heater for Gecko Packs

The 84" x 94" Hot Tub Cover is a Master Spa Factory OEM replacement (SKU: x458494). It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.

Note: This particular hot tub cover folds along its shortest dimension (the 84" side).

The heater gasket o-ring is a replacement part for the o-rings that come with your spa and support the heater gasket so that there is a tight fit. If you don’t see your model listed, it may still work – so please give our customer service a call!

MS300 AVU Control Pack with 4kW 825 Heater. This is for a 1 pump set up. 

5.5 kW Heater with cord and 3rd Sensor

2 x 2 inches Heater Tailpiece with Gasket