Search results for: 'cleaning your tub in the spa'

Copper Heater Straps are used for connection of the Heater Unit of your spa to the Board within the Spa pack.

Easily installed.

As the "command center" of your spa, the circuit board is tasked with making sure your blowers, lights, air filtration system, and high-limit sensors work correctly. Whether you're looking to replace your Down East Spas MS510/1500/1600 Ext. PCB (V/N 53681) or another unit, Master Spa Parts offers a vast selection of replacement circuit boards. These are all competitively priced and ready to ship.

The Circuit board replacement for Twilight Series™ Spas always ships typically within 24 hours to customers ordering this and other spa circuit boards through the Master Spa Parts online store.

Measure the chemical balance of your hot tub water with AquaChek Silver 7-Way Test Strips in just 15 seconds.

• Count: 100 test strips
• Tests for: Total Hardness, Total Chlorine, Total Bromine, Free Chlorine, pH, Total Alkalinity, Stabilizer (Cyanuric Acid).

The 2 Inch Diverter Handle - Black by Master Spas is a replacement for your home spa’s original water diverter valve handle. This piece is the lever that allows you to switch your water diverter valve off and on. Keeping your water diverter valves in good condition is important, as they allow you to control water flow in your spa.

Enjoy remote control access to your spa entertainment system with the EL Series IR Receiver.

Swim Spa Turbo Power Jet

The 2 Inch Diverter Valve in Grey by Master Spas is a replacement for your home spa’s original diverter valve, the part of your spa that allows you to control jet water flow. This assembly kit comes with all of the pieces you need to install a new diverter valve in your spa.

Master Spa Parts offers this Outer Filter for Getaway Spas Eco Pur Charge System. This replacement filter weights 1.2 pounds and is five inches in diameter. This part has a SKU number of x268550 and is also known as a Getaway Outer Filter PMA-R5.

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.

The pivot arm for the CoverMate III is a direct OEM factory replacement for the original bar.

Keep all your essential spa controls within reach with the topside controller for 2017 Twilight Series™ models from Master Spas®. This unit features touch control operation for ease of use. This touch panel only comes with the unit itself, not the protective overlay sticker.

This topside controller comes with free shipping to the continent United States, courtesy of Master Spa Parts!

This is the replacement for X310209, X310213 S/N: 50610 and X310308.

This is a OEM factory direct replacement rubber stopper smash cap for the CoverMate I hot tub cover. Easily replace your old smash cap with this replacement!