Search results for: 'from cup cap specific spa tiny holder round'

BWG Heater Plug N Click Adapter

This adapter eliminates the copper straps going from the heater to the circuit board. 

**This needs to be used on all heaters that come with the plug that is already attached. Removing the plug on the heater will void the warranty.**

The 12-inch A&B M7 Temp/High Sensor is a replacement sensor for several Spa models including the Clarity, Down East, Contractor, Freedom, Getaway, H2X Swim Spas, Healthy Living Hot Spas, Legacy Whirlpool, Legend Series Master Spas, Michael Phelps Swim Spas and Twilight Series Spas. If you don’t see your model listed, it may still work – so please give our customer service a call!

The O-Ring for Power WOW Drain Plug is the O-ring that goes with the drain plug for the Pentair Power WOW pump (SKU : X275230).This creates a tight seal for wet end drain.

SpaBoss X-It makes it easy to switch sanitizers or to lower excessively high levels of chlorine or bromine in your spa or hot tub without having to drain and refill the whole thing.

Threaded Mini-Storm Directional Jet DSG/Grey/Black

The Bracket Kit for CoverMate I is one of the parts that makes up this model of a hydraulic cover lifter. This Bracket Kit for CoverMate I SKU number is: 100267.It is recommended that you do not use the CoverMate I during high winds as to protect the cover and the hydraulic cover lifter from possible damage.

The Master Spa® Factory OEM 84" x 66" replacement hot tub cover is designed to fit your Master Spas® hot tub. This replacement custom hot tub cover is extremely energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.

Twilight Spas 2 Pump Overlay Set

This is the replacement Bracket Kit for CoverMate II and it can be screw-mounted low on the spa. The Bracket Kit for the CoverMate II is for a model that needs only 18 inches of clearance behind the spa in order to operate. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate II Cover Lift. This part is sold for $73.45 here at Master Spa Parts.

The Ultralift Undermount conversion kit allows for you to change your standard cover lift into one with an undermount. With this undermount, there is no more drilling into the side of your spa to install a cover lifter. This is bought in addition to a Ultralift cover lifter.

This pivot arm assembly is made for your CoverMate Freestyle cover lifter.

Measure the chemical balance of chlorine based water with AquaChek Chlorine 4-in-1 Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Free Chlorine, pH, Total Alkalinity, Stabilizer (Cyanuric Acid)