Search results for: 'Small jet part'

Control your spa entertainment system using this waterproof unit. UV and Salt resistant Wired Stereo Remote is designed and built to withstand the harsh conditions that come with spa use.

This is the Locking Shock for the Cover Valet.

This locking shocks for your Cover Valet are the OEM, replacement part for the original shocks on the cover valet equipment.

The Coupler insert (2 per unit) is a long part used to lengthen your raise and lower bar for your hot tub cover.

The Left Support Arm for CoverMate III Eco B is one of the parts that makes up this economically efficient choice for a hydraulic cover lifter. The Left Support Arm connects to the support arm and is sold here by Master Spa Parts. Prevent possible damage to the lift by remembering to unlock the shock before pulling the CoverMate Cover down.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left support arm is on left side.*

The Grey Terminal Block for H2X is designed specifically to work with your H2X Swim Spa. Feed through up to 750V through this Terminal Block.

The Windsor STS TV Lift Stand is a replacement TV Lift for your Windsor Spa Model STS (standard television set). Enjoy your favorite TV programming in your tub from any angle.

The pump marvel drains up to thirteen times faster than siphoning or draining! Unlike a garden hose, this pump does not lose its prime, and can lift and discharge water up to 20’ high. Don’t be fooled, the pump marvel is not a siphon, it’s a true pump! Please note that this pump does not take electricity.

The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.

The O-Ring for Power WOW Drain Plug is the O-ring that goes with the drain plug for the Pentair Power WOW pump (SKU : X275230).This creates a tight seal for wet end drain.

The 20 Amp Fuse by Master Spas is an exact replacement part for your original fuse. It is made to go in your spa’s PC board and supply power to the rest of your spa and its features. The piece is durable, affordable and will provide prolonged enjoyment of your spa.

This heater is a replacement part for the original heater in your Master Spas swim spa and hot tub models. Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

This is an original heater assembly made by Balboa Group - leaders in manufacturing spa parts.

Features:

This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.