Search results for: 'hot spas spas 7.5'

At Master Spa Parts, we carry the Master Spas® Legend® Series Topside Controller Decal to replace controller overlays from the late 1990s and early 2000s. This Standard Series Overlay features beautiful graphics and will stand up to years of constant heat and humidity.

The 2 Inch Diverter Handle - Black by Master Spas is a replacement for your home spa’s original water diverter valve handle. This piece is the lever that allows you to switch your water diverter valve off and on. Keeping your water diverter valves in good condition is important, as they allow you to control water flow in your spa.

The Pump 9.8 Amp, 2 Speed, 120V is a replacement pump for (but not limited to) Clarity Spas and Twilight series spas. Don’t let a broken pump spoil your fun. Order your replacement today.

This 4.0 kW heater that is easily installable so you can get back to enjoying your heated swim spa or hot tub in no time at all. 

**REMOVING THE PLUG N CLICK OR EYELET CABLE FROM THE HEATER WILL VOID THE MANUFACTURES WARRANTY**

The Waterfall Diverter Valve, 1/2" 3-WAY GREY by Master Spas is a replacement part for your home spa’s original waterfall diverter valve. The water diverter valves in your spa allow you to control when and where water flows. The Waterfall Diverter Valve, 1/2" 3-WAY GREY is durable, affordable and easy to install at home.

Copper Heater Straps are used for connection of the Heater Unit of your spa to the Board within the Spa pack.

Easily installed.

This 4.0 kW heater that is easily installable so you can get back to enjoying your heated swim spa or hot tub in no time at all. 

**REMOVING THE PLUG N CLICK OR EYELET CABLE FROM THE HEATER WILL VOID THE MANUFACTURES WARRANTY**

If replacing one suction cover, it is highly recommended that you replace all of them to be compliant. These suction covers are available for replacement of your older suction covers (spa models pre-2009). There is however no guarantee that these suction covers will fit your pre-2009 spa.

Thumbscrew 1/4 - 20 x 1.75 inch. These are used to secure your corner skirting pieces on your spa in place. This part is the longer of the two thumb-screws available.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

This 5.5 kW heater that is easily installable so you can get back to enjoying your heated swim spa or hot tub in no time at all. 

**REMOVING THE PLUG N CLICK OR EYELET CABLE FROM THE HEATER WILL VOID THE MANUFACTURES WARRANTY**

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.