Search results for: 'tub spa halo cover17 parts tp500'

The Pivot Arm for CoverMate III Eco B is one of the parts that makes up this economically efficient choice for a hydraulic cover lifter. The Pivot Arm connects to the mounting brackets and the support arms and is sold here by Master Spa Parts. It is recommended that you do not use the CoverMate III Eco B during high winds as to protect the cover and the hydraulic cover lifter from possible damage.

This is the Extended Pivot Arm for CoverMate III and it is a replacement part for your CoverMate III Cover Lift. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate III Cover Lift. This part is 43 inches long and is sold here at Master Spa Parts.

SpaEase Classic Espresso SteP

5", SST/Pismo Blue Cyclone. These jets are used in Master Spas Healthy Living hot tubs starting in 2013.

Swirl Jet

Single Filter Housing for Swim Spas

SpaBoss pH Plus easily raises pH levels in spas and hot tubs that are too low below the recommended safe range of 7.2 to 7.6. If levels are too low, your hot tub water can become acidic and other nasty side effects can happen.

If replacing one suction cover, it is highly recommended that you replace all of them to be compliant. These suction covers are available for replacement of your older suction covers (spa models pre-2009). There is however no guarantee that these suction covers will fit your pre-2009 spa.

The 2 inch Standard Pump Union is a standard pump union used for complete assembly of your replacement pump. Should fit any 2 inch end on most pumps.

This is the OEM factory replacement screw kit for your CoverMate CoverShelf.

The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.

MP Swim Spa, Swim Side Control Panel MP9

Trim Kit for Wave TR19/MOM Swim Spa