Search results for: 'tubs spa hard cover13 parts'
- Did you mean
- tubs spa hard covers parts
- tubs sp2 hard cover13 parts
- Related search terms
- Spa mavel
- spa filter 50353
- Spa floor system
- spa hot tub pillow receptacle
- spa Chlorine Granules for Hot Tub
The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.
-
MP Swim Spa, Swim Side Control Panel MP9
-
This is the replacement part for the Plastic Bracket Left for CoverMate III for your CoverMate III Cover Lift. Our stylish composite mounting brackets combined with aluminum full-frame construction provides a perfect hydraulic cover lift option with no heavy lifting needed. This part is retails for $47.20 and is sold here at Master Spa Parts.
*To determine if this is the correct replacement bracket you need, look at your cover in the open position. While facing the spa and open cover lifter, the left bracket is on the left side.*
-
The 11 amp, 2 speed 120 volt Pump is an insulated wet end pump designed as a replacement pump.
-
The Coupler insert (2 per unit) is a long part used to lengthen your raise and lower bar for your hot tub cover.
-
The Shock Locking for CoverMate III Eco B is one of the parts that make up this economically efficient choice for a hydraulic cover lifter. The Shock Locking connects to the shock itself and is sold for $34.50 by Master Spa Parts. It is recommended that you do not use the CoverMate III Eco B during high winds as to protect the cover and the hydraulic cover lifter from possible damage.
-
This right support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover.
*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the right arm is on the right side.*
-
The 2 Inch Diverter Valve in Grey by Master Spas is a replacement for your home spa’s original diverter valve, the part of your spa that allows you to control jet water flow. This assembly kit comes with all of the pieces you need to install a new diverter valve in your spa.
-
The 1.5 inch standard pump union is a universal pump union used for complete assembly of your replacement pump. Should fit any 1.5 inch end on most pumps.
You need this to fully assemble your pump.
-
The Master Spa® Factory OEM 78" x 78" (6.5') replacement hot tub cover (SKU: X457878) is specifically designed to fit your Master Spas® hot tub. This replacement custom hot tub cover ensures energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.
.
