Search results for: 'spa cover13 series 8.35 sku x320272'
- Related search terms
- spa panel screws
- Spa jet body 3"
- spa boss 7#spa shock
- Spa water filler
- Spa Cover Mate II - Undermount Manual-Pivot Lifter
This is the Plastic Bracket Right for CoverMate III and it is a replacement part for your CoverMate III Cover Lift. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate III Cover Lift. This part retails for $47.20 here at Master Spa Parts.
**To determine if this is the correct replacement bracket you need, look at your cover in the open position. While facing the spa and open cover lifter, the right bracket is on the right side.**
-
The Wrap Around Pillow from Master Spa is a larger pillow that wraps around the corner of your hot tub.
-
Threaded Mini-Storm Directional Jet DSG/Grey/Black
-
This is a factory replacement plastic bracket for your CoverMate CoverShelf.
-
The 11 amp, 2 speed 120 volt Pump is an insulated wet end pump designed as a replacement pump.
-
The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.
-
The Down East Lounge Pillow perfectly matches the original pillow that fits in your Down East hot tub from Master Spas.
-
The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.
Make sure to buy all the parts you need for complete assembly of your replacement pump.
-
KEC Remote Eye. Control your spa’s theater system from the comfort of your hot tub. The KEC Remote Eye turns your clicks on your remote into executable commands that allow you to switch the channels on your television or radio.
-
The 2 inch Standard Pump Union is a standard pump union used for complete assembly of your replacement pump. Should fit any 2 inch end on most pumps.
-
Copper Heater Straps. These are the longer style heater straps. These are the most common heater straps. These heater straps are used to connect power from the PC board and the heater.
