Search results for: 'spa parts left vent'

This Master Spa Factory OEM 78” x 78” hot tub cover replacement (SKU: X120240)  is specifically designed to fit your Master Spas® hot tub. This cover is energy efficient as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full length heat seal to help prevent heat loss. It is also made of a high end marine-grade vinyl covering that is mildrew treated, and consists of upgraded rubber grip handles.

The pivot arm for the CoverMate III is a direct OEM factory replacement for the original bar.

Replacement support arm for the CoverMate I Eco B and the inner support arm for the CoverMate Freestyle.

Clamp, Hose 9/16 inch -1 1/16 inch SST

The Master Diverter Valve Handle is a genuine oem replacement part for your Master Spas hot tub. Diverter valves are made to redirect the water from your spa into different directions, as well as fully (or partially) shutting off your hot tub water flow. This specific diverter valve has a 2”inch handle and has an all over width of 4.5” inches.

The Coupler insert (2 per unit) is a long part used to lengthen your raise and lower bar for your hot tub cover.

The Neck Jet Pillow from Master Spa fits in place of the hot tub pillow that came with your hot tub.

Topside control panel extension cord 25'

3/4" Eclipse DSG/Titanium Waterfall diverter

The pivot arm is a direct replacement for the original bar on the CoverMate I and CoverMate I Eco B.

This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.

The right outer handle is a powder-coated aluminum part that is used to easily open and close your CoverMate Freestyle.

*To determine if this is the correct replacement handle you need, look at your cover in the open position. While facing the open cover, the right handle is on right side.*