Search results for: 'master spx twilight series ts 8.8 control panel replacement'
- Did you mean
- master sx twilight series ts 8.8 control panel replacement
- master spx twilight series ts 8.3 control panel replacement
- Related search terms
- Master Spa - CLSEPRSET3 - Clarity & Healthy Living EPR Filter Set - (2) X268548 - PMA-R3 and PMA-EPR - (1) X268532
- Master Spas - X268532 - PMA-EPR, Eco Pur Charge Master Core Technology Mineral Filter - X268532
- master-spa-s-legacy-and-freedom-filter
- Master Spas - Х310223 Topside Control, MP2 ST1 Custom SFTW, H2X Swim Spa, MP2 X310223 (New Part Number X310334)
- Master spa 1" air control valves
The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.
-
The 66" x 78" Master Spas® factory direct OEM replacement hot tub cover (SKU: 66x78) is designed to fit your Master Spas hot tub. It comes standard with a 1.5lb foam density, long steam stopper cushions to help prevent any sort of heat loss. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.
Note: This particular cover folds along the short edge. If you need a cover with these same dimensions (66" x 78") but that folds along the long edge, try our 66 × 78 Inch Hot Tub Cover (Long-edge fold).
-
The Charcoal Neck Pillow is a replacement pillow for charcoal colored neck pillows for some Down East Spas.
-
This screw kit is a bag of screws used for installation with the CoverMate I Eco B. They are factory direct, OEM replacement parts!
-
The 1.5 inch standard pump union is a universal pump union used for complete assembly of your replacement pump. Should fit any 1.5 inch end on most pumps.
You need this to fully assemble your pump.
-
240V Transformer Balboa Instruments
-
The 11 amp, 2 speed 120 volt Pump is an insulated wet end pump designed as a replacement pump.
-
Washer for the regular sized Snap Caps. These are the beauty caps that cover the screws that hold your side panels on providing your spa with a professional beautiful finish.
-
This is the Pivot Arm for CoverMate II and you will first need to remove the bolt connecting it to the spa mount bracket in order to replace it. The CoverMate II needs 18 inches of clearance behind the spa in order to operate. This part will ship to you free if it is part of a total order that is over $99 from Master Spa Parts.
