Search results for: 'non swim part from steps and sp flat'

DSG Ozone Wall Fitting

Boomerang brackets (1 pair) are specifically designed for use with the Visionlift Boomerang Cover Lifter by Ultralift. These brackets attach to your existing Ultralift sliding bracket, allowing your hot tub cover to fully open to the ground without the need for additional drilling. 

This kit is a factory direct, replacement screw kit that contains a bag of screws used for installation with the CoverMate III Eco B.

This replacement plastic screw kit is the main screw kit you need for your CoverMate 1 by Leisure Concepts.

Skimmer, Vane w/ Vent Hole

3-Way Jumper for MS5000. Wire jumper for components to plug into one spot on the pc board. Usually used with the circulation pump and ozone.

The Waterfall Diverter Valve, 1/2" 3-WAY GREY by Master Spas is a replacement part for your home spa’s original waterfall diverter valve. The water diverter valves in your spa allow you to control when and where water flows. The Waterfall Diverter Valve, 1/2" 3-WAY GREY is durable, affordable and easy to install at home.

This is the H2X Shaft Pin with SKU number X400130 and is one element that goes with the Blade Prop Kit. The H2X Shaft pin is a prop shaft pin and is a component of the wave propulsion.

The 84" x 94" Hot Tub Cover is a Master Spa Factory OEM replacement (SKU: x458494). It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.

Note: This particular hot tub cover folds along its shortest dimension (the 84" side).

MS8000 Relay for FST. This unit reverses polarity of the power in your spa’s entertainment system to raise and lower the television.

This replacement spa light bulb is one element to the lighting system and is specific to the 2012 Contractor Series models CS 360 and CS 415. Spa light bulbs help to bring a unique ambience to your home spa.

The right outer handle is a powder-coated aluminum part that is used to easily open and close your CoverMate Freestyle.

*To determine if this is the correct replacement handle you need, look at your cover in the open position. While facing the open cover, the right handle is on right side.*