Search results for: 'swirl spa spa up chemicals'

The Master Diverter Valve Handle is a genuine oem replacement part for your Master Spas hot tub. Diverter valves are made to redirect the water from your spa into different directions, as well as fully (or partially) shutting off your hot tub water flow. This specific diverter valve has a 2”inch handle and has an all over width of 4.5” inches.

The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

This product is a pressure switch assembly specifically designed to go with select Down East and Legend Series Master Spas. If you don’t see your model listed, it may still work – so please give our customer service a call!

The Grey, Legend Wrap-Around Pillow is made to go with the Master Spa Legend Series Hot Tubs (2005-2009).

This is a gasket ring that is five-inches in diameter and is sold by Master Spa Parts. This replacement piece has a SKU number of X241056 and is made of quality plastic to prevent leaks. The five-inch gasket ring is easy to install on your home spa. This part ships for free throughout the continental U.S. when included in an order of $99 or more.

Filter Bulkhead Wall fitting Assembly

Designed specifically for 2015 Michael Phelps Swim Spas this sensor is a replacement for the sensor in your spa’s heating system allowing you to control the heat of your spa from the external control panel. If you don’t see your model listed, it may still work – so please give our customer service a call!

Washer for the regular sized Snap Caps. These are the beauty caps that cover the screws that hold your side panels on providing your spa with a professional beautiful finish.

The 1/4-20 Threaded Insert for Wood from Master Spa Parts are threaded nuts that can be hammered or screwed into material. Used in a pre-drilled hole to provide an extra secure hold between your spa skirting parts.

The 78" x 66" Hot Tub Cover (Long-edge Fold) is an exact Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated.

Note: This particular cover folds along the longer 78" edge. If you need a cover with these same dimensions (66" x 78") but that folds along the short edge, try our 66 × 78 Inch Hot Tub Cover (Short-edge fold).

MS300 AVU Control Pack with 4kW 825 Heater. This is for a 1 pump set up. 

This is the Plastic Bracket Right for CoverMate III and it is a replacement part for your CoverMate III Cover Lift. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate III Cover Lift. This part retails for $47.20 here at Master Spa Parts.

**To determine if this is the correct replacement bracket you need, look at your cover in the open position. While facing the spa and open cover lifter, the right bracket is on the right side.**