Search results for: 'Build your own spa kit'

This is the Right Support Arm for the CoverMate III Eco B cover lifter.

*To determine if this is the correct replacement support arm need, look at your cover in the open position. While facing the spa and open cover lifter, the right support arm is on the right side.*

The O-Ring for Power WOW Drain Plug is the O-ring that goes with the drain plug for the Pentair Power WOW pump (SKU : X275230).This creates a tight seal for wet end drain.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

Threaded Mini-Storm Directional Jet DSG/Grey/Black

The 11 amp, 2 speed 120 volt Pump is an insulated wet end pump designed as a replacement pump.

This Master Spa Factory OEM 66" x 84" hot tub cover replacement (SKU: X456684) is specifically designed to fit your Master Spas® hot tub. This cover ensures energy efficiency as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.

Note: This particular hot tub cover folds along the short edge. Find the corresponding long-edge fold cover here.

Twilight Spas 2 Pump Overlay Set

Durable latching Piezo Switch allows customers to easily control the power supply to devices. Lighted switch tells the customer that an electric pulse is being generated and vice versa. Waterproof and especially designed to work with Master Spa hot tub series

1 inch, Clear Rubber Grommet for Weir Waterfall

The coupler is used to connect the lower and side portions of your CoverMate Easy product.

The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.

The Upper Bracket Assembly attaches to the pivot arm, which allows a smooth opening and closing of your CoverMate Freestyle.