Search results for: 'white to fast tee module number of your spa'

The bracket is used for CoverMate easy to install the pole directly to your hot tub.

Skimmer Tray

The Master Spa® Factory OEM 84" x 66" replacement hot tub cover is designed to fit your Master Spas® hot tub. This replacement custom hot tub cover is extremely energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.

This extender bracket set is used for and with the Leisure Concepts CoverMate III Eco B Cover Lifter

Check Valve

1 1/2 inch SxSp Gate Valve

This Master Spa Factory OEM 79" x 69" hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures energy efficiency as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.

Note: This 79" x 69" hot tub cover folds along the long edge. 

PREMIUM UNDERMOUNT HOT TUB COVER LIFTER
-Works with all cover shapes
-Undermount design- no screwing into spa
-Gas spring assisted

**Swim spa kit available for units up to 54" tall

Save money with this three-piece EcoPur® Charge filter set! This set includes x268532, x268543, x268546 from Master Spa Parts (and replaces SKU #268603). 

This is the Right Support Arm for the CoverMate III Eco B cover lifter.

*To determine if this is the correct replacement support arm need, look at your cover in the open position. While facing the spa and open cover lifter, the right support arm is on the right side.*

The O-Ring for Power WOW Drain Plug is the O-ring that goes with the drain plug for the Pentair Power WOW pump (SKU : X275230).This creates a tight seal for wet end drain.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.