Search results for: 'sundance sp1 suv parts mineral sp2 sanitizer'

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

The 8.8 Amp 2 speed 56 Frame Pump from Master Spa Parts is designed for flexibility and performance.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

The Drain Plug for Power WOW is a wet end drain plug for the Pentair Power WOW. This part does not come with an O-ring. The part allows the pump to be drained of stagnant water so protect it from damage and to keep it running for as long as possible.

The 4.0kW Heater (V/N 50143) is a replacement part for selected models of the Down East Spas and Legend Series Master Spas

Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

This heater is a replacement part for the original heater in your Legend Series Master Spas models 1996 through 2001.Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The 4.0kW Heater (V/N 55950) is a replacement part for selected models of the H2X Swim Spas (Momentum 80, H2X Momentum) and Michael Phelps Swim Spas (Momentum 80)

Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.

The pressure switch - MAS400 - is specifically designed to replace the original pressure switches in the Legend Series Master Spas 2000 CS models. Control the water pressure in your spa with the right part.

SpaBoss pH Plus easily raises pH levels in spas and hot tubs that are too low below the recommended safe range of 7.2 to 7.6. If levels are too low, your hot tub water can become acidic and other nasty side effects can happen.

Designed specifically for the Legend Series Master Spas and the Michael Phelps Swim Spas starting with the 2014 model, the Temperature Sensor Mount is a replacement part that will fit the temperature sensor (SKU : 801821). If you don’t see your model listed, it may still work – so please give our customer service a call!

The 120V Lift Motor is a gear motor to lift and power TV lift systems that come with the 2001-2003 Master Spa entertainment systems. This is for older spa models so give us a call to make sure it is the right part for you.