Search results for: 'hot to maintain your spa'

This is the Pivot Arm for CoverMate II and you will first need to remove the bolt connecting it to the spa mount bracket in order to replace it. The CoverMate II needs 18 inches of clearance behind the spa in order to operate. This part will ship to you free if it is part of a total order that is over $99 from Master Spa Parts.

This extender bracket set is used for and with the Leisure Concepts CoverMate III Eco B Cover Lifter

This kit is a factory direct, replacement screw kit that contains a bag of screws used for installation with the CoverMate III Eco B.

Check Valve

1 1/2 inch SxSp Gate Valve

This is the Right Support Arm for the CoverMate III Eco B cover lifter.

*To determine if this is the correct replacement support arm need, look at your cover in the open position. While facing the spa and open cover lifter, the right support arm is on the right side.*

The O-Ring for Power WOW Drain Plug is the O-ring that goes with the drain plug for the Pentair Power WOW pump (SKU : X275230).This creates a tight seal for wet end drain.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

The SmartRail is a hand rail for recessed spas. With the SmartRail, Leisure Concepts solved the top pain points of those with recessed spas: finding a hand rail that is not only compatible with their setup, but one that is also easy to install. This product comes with free shipping to the Continental USA, compliments of Master Spa Parts.

Threaded Mini-Storm Directional Jet DSG/Grey/Black

The 11 amp, 2 speed 120 volt Pump is an insulated wet end pump designed as a replacement pump.

This replacement plastic screw kit is the main screw kit you need for your CoverMate 1 by Leisure Concepts.