Search results for: 'hot to start up down east spas'

The pressure switch - MAS400 - is specifically designed to replace the original pressure switches in the Legend Series Master Spas 2000 CS models. Control the water pressure in your spa with the right part.

2 x 3/4 inch 4 Barb SxSp Manifold

Support arm for CoverMate I and upper support arm for the CoverMate II and CoverMate Easy.

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.

The 2 Inch Diverter Handle - Black by Master Spas is a replacement for your home spa’s original water diverter valve handle. This piece is the lever that allows you to switch your water diverter valve off and on. Keeping your water diverter valves in good condition is important, as they allow you to control water flow in your spa.

The Pump 9.8 Amp, 2 Speed, 120V is a replacement pump for (but not limited to) Clarity Spas and Twilight series spas. Don’t let a broken pump spoil your fun. Order your replacement today.

Copper Heater Straps are used for connection of the Heater Unit of your spa to the Board within the Spa pack.

Easily installed.

Foam Grip for CoverMate I, CoverMate III, CoverMate Easy and CoverMate Freestyle. This is the upper Foam Grip for the CoverMate II.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

Replacment Overlay for Twilight Spas MP13 Topside

This is a replacement 8" 304 Stainless Handrail from Master Spas.