Search results for: 'sliding from caldera spa'
- Did you mean
- sliding forc caldera spa
- sliding foam caldera spa
- Related search terms
- Spa boss cartage cleaner
- spa pillof for x2x swim spa
- Spa electric light swit ch
- spa pack circuit board
- Spa screws x710703
The Left Support Arm for CoverMate III Eco B is one of the parts that makes up this economically efficient choice for a hydraulic cover lifter. The Left Support Arm connects to the support arm and is sold here by Master Spa Parts. Prevent possible damage to the lift by remembering to unlock the shock before pulling the CoverMate Cover down.
*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left support arm is on left side.*
-
This is a OEM factory direct replacement rubber stopper smash cap for the CoverMate I hot tub cover. Easily replace your old smash cap with this replacement!
-
1 inch, Clear Rubber Grommet for Weir Waterfall
-
Thumbscrew 1/4 - 20 x 1.75 inch. These are used to secure your corner skirting pieces on your spa in place. This part is the longer of the two thumb-screws available.
-
The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.
-
The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.
Make sure to buy all the parts you need for complete assembly of your replacement pump.
