Search results for: 'pump overlay from split seri spas'
- Related search terms
- SplitNutSet - (2) X802900 - Spa Heater Split Nut and (2) X801765 - Heater Gasket O-Ring
- pump for pheonix spa PHX01?
- Spas-Eco Pur Charge Filter Set-X268549-PMA-R4-X268532-PMA-EPR-X268542-PWW50P3
- Pump seal kit for 2001 down east Exeter spa
- Pump motor for 2004 1100 down east spa
The Bracket Kit for Master Spas CoverMate I with Master Bracket is one of the sections that makes up the CoverMate I model of a hydraulic cover lifter. This Extended Pivot Arm has SKU# 100571 and is a replacement part for the CoverMate I, which is sold here by Master Spa Parts. The Master bracket attaches to the wood in the upper-right corner to provide additional support.
-
The 20 Amp, ABC20 Glass Fuse for H2X by Master Spas is a replacement fuse designed to go in your home spa’s PC board. It is important to keep the fuses in your spa’s PC board in good shape because they provide power to your spa and all of its features.
-
This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.
-
The 2 Inch Diverter Handle - Black by Master Spas is a replacement for your home spa’s original water diverter valve handle. This piece is the lever that allows you to switch your water diverter valve off and on. Keeping your water diverter valves in good condition is important, as they allow you to control water flow in your spa.
-
Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.
This mount should fit with most sensors.
-
The Waterfall Diverter Valve, 1/2" 3-WAY GREY by Master Spas is a replacement part for your home spa’s original waterfall diverter valve. The water diverter valves in your spa allow you to control when and where water flows. The Waterfall Diverter Valve, 1/2" 3-WAY GREY is durable, affordable and easy to install at home.
-
2 x 3/4 inch 4 Barb SxSp Manifold
-
Copper Heater Straps are used for connection of the Heater Unit of your spa to the Board within the Spa pack.
Easily installed.
-
The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.
-
Replacement screw kit for the CoverMate I Master Bracket. This kit includes all of your replacement screws for your cover lifter bracket.
-
The 100mA (0.1A) is a replacement fuse meant to go in your home spa’s PC board. This fuse supplies power to your spa and the rest of its features, so maintaining it is key to the enjoyment of your spa. The slow blow fuse allows more power to flow without overwhelming the circuit.
