Search results for: 'prevent ipod build in sp2'

SpaBoss Descummer boosts the effectiveness of the filtration system in your spa or hot tub, helping to keep the water clean and free of left-over contaminants.

The 78" x 66" Hot Tub Cover (Long-edge Fold) is an exact Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated.

Note: This particular cover folds along the longer 78" edge. If you need a cover with these same dimensions (66" x 78") but that folds along the short edge, try our 66 × 78 Inch Hot Tub Cover (Short-edge fold).

*Due to a nationwide shortage of chlorine, prices have increased and supply is very low.*

Spa Ease Oxy Blast can be used as a substitute.

---

SpaBoss Spa Shock (7lb.) is a non-chlorine shock, that is the key to keeping your chlorine or bromine sanitizers working like they should. It will help to get rid of the nasty residue from soap, oils, deodorants, and other organic materials that get into hot tubs from regular use. Comes in a 7lb. container.

The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.

Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.

Proline Jet Line Cleaner clears your hot tub jets of all unwanted organics, oils, residue, dirt, minerals and biofilm. It's a great way to keep your hot tub jets clean, clear, and working properly!

Get rid of excess foam in your hot tub quickly and prevent foam from ruining your enjoyment and relaxation! SpaBoss Defoamer is safe to use even if you’re in the hot tub at the same time.

Spa Marvel Startup Kit

The Pump Pad is your key to a quieter running spa/hot tub. Mount your pump on the pad to prevent transmission of the noise and vibration from the motor in your pump. Works well with pumps on most models.

General use 5/16 SS Washer from Master Spa Parts. This unit goes underneath fasteners on your spa/hot tub to keep components of your propulsion system intact.

This is the 2” gasket that goes with the Laing circulation pump found in your spa or hot tub. Replace broken gaskets to prevent leaks and ensure you and your loved ones enjoy your hot tub in safety.

Measure the chemical balance of your hot tub water with AquaChek Spa 6-in-1 Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Chlorine, Total Bromine, Free Chlorine, Total Alkalinity, pH and Total Hardness.