Search results for: 'touch assembly master sp1'
- Did you mean
- touch assembly master spa
- touch assembly master spx
- Related search terms
- Master Spa Topside Control Unit MP-600 X 310130
- Master Spa - CLSEPRSET3 - Clarity & Healthy Living EPR Filter Set - (2) X268548 - PMA-R3 and PMA-EPR - (1) X268532
- Master Spa - X232607 - 1" Lighted Halo Air Control
- Master Spas - Topside Panel, MP900, No Overlay, For MS40 - X310203, 50305
- Master Spas, Down East, Emerald Spas Suction Drain Cover, 4-7/8 inch 0.D. VGB Law Compliant Replaced 0bsolete Original
This heater is a replacement part for the original heater in your Master Spas swim spa and hot tub models. Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.
This is an original heater assembly made by Balboa Group - leaders in manufacturing spa parts.
Features:
-
The 1.5 x 2 inch Pump Adapter tailpiece is a pump assembly part commonly used to create a tight seal between pump parts along with the O-ring.
Make sure to buy all the parts you need for complete assembly of your replacement pump.
-
The 1.5 inch standard pump union is a universal pump union used for complete assembly of your replacement pump. Should fit any 1.5 inch end on most pumps.
You need this to fully assemble your pump.
-
The Master Diverter Valve Handle is a genuine oem replacement part for your Master Spas hot tub. Diverter valves are made to redirect the water from your spa into different directions, as well as fully (or partially) shutting off your hot tub water flow. This specific diverter valve has a 2”inch handle and has an all over width of 4.5” inches.
-
The 1 Inch, T Grey Diverter Handle by Master Spas is an exact replacement piece for your home spa’s original diverter handle. The part is small, durable and easy to install. This item is a great product to purchase if you only need to replace the handle of your diverter assembly.
-
The 2 Inch Diverter Handle - Black by Master Spas is a replacement for your home spa’s original water diverter valve handle. This piece is the lever that allows you to switch your water diverter valve off and on. Keeping your water diverter valves in good condition is important, as they allow you to control water flow in your spa.
-
The 2 inch Standard Pump Union is a standard pump union used for complete assembly of your replacement pump. Should fit any 2 inch end on most pumps.
-
This heater is a replacement part for the original heater in your Legend Series Master Spas models 1996 through 2001.Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.
-
The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.
Get all the parts you need to fully assembly your replacement spa pump.
-
Master Blaster Insert Only Grey/Black
