Search results for: 'Icon spa touch top control'

This left cover piece for the CoverMate III cover lifter snaps into the fitted location on the left side and covers all the pieces found there.

*To determine if this is the correct replacement cover pieceyou need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left cover piece is on the left side.*

The Drain Plug for Power WOW is a wet end drain plug for the Pentair Power WOW. This part does not come with an O-ring. The part allows the pump to be drained of stagnant water so protect it from damage and to keep it running for as long as possible.

This is the Right Support Arm for the CoverMate III Eco B cover lifter.

*To determine if this is the correct replacement support arm need, look at your cover in the open position. While facing the spa and open cover lifter, the right support arm is on the right side.*

1/4 inch Washer for Oversized Snap Cap. These are the beauty caps that cover the screws that hold your side panels on. Available in 2 different sizes and 3 different colors.

This is the Extended Pivot Arm for CoverMate III and it is a replacement part for your CoverMate III Cover Lift. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate III Cover Lift. This part is 43 inches long and is sold here at Master Spa Parts.

Filter Basket Only

9" Waterfall Lid

The Ultralift Undermount conversion kit allows for you to change your standard cover lift into one with an undermount. With this undermount, there is no more drilling into the side of your spa to install a cover lifter. This is bought in addition to a Ultralift cover lifter.

This extender bracket set is used for and with the Leisure Concepts CoverMate III Eco B Cover Lifter

Mitsubishi ModBus Daughter 

The 6.5×7 Master Spas® (78" x 84") hot tub cover replacement (SKU: X454657) is specifically designed to fit your Master Spas® hot tub. This cover ensures energy efficiency as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.

Note: This particular hot tub cover folds along the short edge. Find the corresponding long-edge fold cover here.

Replacement Siemmens Breaker for H2X Challenger